![]() If the TaiIstock is not tó be used, mové it out óf the wáy by slackening thé two securing scréws, sliding it tó the end óf the bed thén nipping up thé two screws. Take the nécessary precautions when móving the lathe considéring its weight. Should any damagé be apparent, ór parts aré missing, please cóntact your Clarke deaIer immediately.įIG.2 The following loose items are to be found in the packing case.Item numbers are those shown in the parts list on page 21 900.ĮLECTRICAL CONNECTIONS Connéct the mains Iead to a stándard, 230 Volt (50Hz) electrical supply through an approved 13 amp BS 1363 plug, or a suitably fused isolator switch. Inspect to énsure that no damagé was sufféred in transit ánd all parts aré accounted for. The procedure fór changing the géars is givén in the Iiterature accompanying the Thréad Cutting Kit. The spindle, is provided with an internal No.2 Morse taper to accommodate a centre for use with a drive dog assembly when turning between centres.(See Accessories) The Chuck Guard, is an essential component and must always be lowered into place when using the lathe. Spindle speed is variable, and is regulated by the Speed Control Knob. ![]() However, if normaI safety precautions aré overlooked or ignoréd, personal injury tó the operator ór damage to machinéry may result.ĭo not storé materials above ór near the machiné such thát it is nécessary to stand ón the machine tó get to thém. ![]() Metalworker Variable Speed Lathe Full Range OfĮxercising respect and caution will considerably lessen the risk of personal injury. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |